Configure The Autostart Software; Configure The Autostart Software On Cp1 - Nortel CallPilot Install Manual

28
29
30
Configure the AutoStart software
To configure the AutoStart software, both servers (CP1 and CP2) must be
running and have the HB1, HB2, and MIRROR LANs connected so that the
two servers can communicate using the LAN connections.
Configure the AutoStart software on CP1
Use the procedures in the following section to configure the AutoStart
software on CP1.
Modifying the AutoStart Domain and Verification links
Step
1
Copyright © 2007, Nortel Networks
.
Clear the Check for program updates now check box.
Click Finish.
Result: The EMC AutoStart 5.2.2 Installer Information dialog box
appears.
Figure 73
EMC AutoStart 5.2.2 dialog box
Click No if there are patches to install or click Yes to restart CP2.
Note: If there are patches available, install the patches and
then restart CP2.
Action
Launch the AutoStart Console by selecting Start > Programs >
EMC AutoStart Console > EMC AutoStart Console 5.2.
WARNING
Do not continue the configuration process until CP2 is
finished rebooting.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
Configure the AutoStart software 109
—End—