Configure Cp1 And Cp2 Using The Callpilot Configuration Wizard - Nortel CallPilot Install Manual

48 Chapter 5 Install and configure the High Availability pair
8
9
10
Configure CP1 and CP2 using the CallPilot Configuration Wizard
This section provides the procedures to configure CP1 and CP2 using the
CallPilot Configuration Wizard within CallPilot Manager.
If you must go back into the Configuration Wizard at any time to correct any
entries, note that the Database, LDAP, and AOS services must be started to gain
access to CallPilot Manager.
The D:\Nortel\HA folder contains a file called start_svr.bat that automatically starts
any necessary services. This script can be run to start the required services.
Copyright © 2007, Nortel Networks
.
Select the No, I do not have data to restore option.
Click Next.
Result: The Finished window appears.
Figure 8
Finished window
Click Finish to exit the CallPilot Setup Wizard.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—
ATTENTION