Attaching Mounting Accessories - NEC MultiSync SC40 User Manual

Attaching Mounting Accessories

The display is designed for use with the VESA mounting
system.
1) Attach Mounting Accessories
Mounting accessories can be attached while the monitor
is on a Tabletop Stand (optional) in the upright position
(Figure 1). Be careful to avoid tipping monitor when
attaching accessories. .
If no stand is available, mounting accessories can be
attached with the monitor in the face down position.
To avoid damaging the screen face, place the protective
sheet on the table underneath the LCD. The protective
sheet was wrapped around the LCD in the original
packaging. Make sure there is nothing on the table that
can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the
VESA-compatible mounting method. NEC strongly
recommends using screws M6 size and 10mm in length.
If using screws longer than 10mm, check the depth of
the hole. (Recommended Fasten Force: 470-635N•cm)
NEC recommends using mounting interface that
comply with UL1678 standard in North America.
For proper installation it is strongly recommended to
use a trained, NEC authorized service person. Failure
to follow NEC standard mounting procedures could
result in damage to the equipment or injury to the user
or installer. Product warranty does not cover damage
caused by improper installation. Failure to follow these
recommendations could result in voiding the warranty.
VESA Mounting Interface
Figure 1
Figure 2
Table
English-7
Installation
- continued
Protective Sheet