Mec Micro2032 Service & Parts Manual page 17

Section 9 - Transport and Lifting Instructions
Driving or Winching onto or off of a Transport Vehicle
ART_6091
WARNING
Before loading or unloading the machine, check that:
• The deck extension, controls and component trays are secure.
• The platform is fully lowered.
• All loose items have been removed.
Before driving or winching the machine:
• Attach the machine to a winch.
• Remove all machine tie downs. Remove wheel chocks.
Driving
• Turn the Base Key Switch to Platform. Check that the Emergency Stop button is reset by pulling
the button out to the On position (pulled out).
• Enter the platform and reset the Platform Emergency Stop Switch.
• Test platform control functions.
Select slow drive speed mode. Carefully drive the machine off the transport vehicle with the
•
winch attached.
Note: The brakes are automatically released for driving and will automatically apply when the
machine stops.
Winching
Disengage brakes (see Free-wheel configuration for Winching or Towing on page 12).
•
• Carefully operate the winch to lower the machine down the ramp.
• Chock the wheels and engage the brakes.
ART_6091
CAUTION
Lifting the machine with a Forklift
• Position the forklift forks in line with the forklift pockets.
• Drive forward to the full extent of the forks.
• Raise the machine 6 inches (15 centimeters) and then tilt
the forks back slightly to keep the machine secure.
• Be sure the machine is level when lowering the forks.
Page 13
Always attach the machine to a winch when loading or unloading from a
truck or trailer by driving.
Read and understand all safety, control, and operating information found
on the machine and in this manual before operating the machine.
Lifting the machine from the side may result in component damage.
Micro2032 - Service & Parts Manual - 96898
December 2024
ART_5030