Safety Instructions - Lightware DVI-OPT-TX220-Pro User Manual

SAFETY INSTRUCTIONS

Class I apparatus construction. This equipment must be used with a main power system
with a protective earth connection. The third (earth) pin is a safety feature, do not bypass
or disable it.
This equipment should be operated only from the power source indicated on the product.
To disconnect the equipment safely from power, remove the power cord from the rear of
the equipment, or from the power source. The MAINS plug is used as the disconnect
device, the disconnect device shall remain readily operable.
There are no user-serviceable parts inside of the unit. Removal of the top cover will expose
dangerous voltages. To avoid personal injury, do not remove the top cover. Do not operate
the unit without the cover installed.
The apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
The apparatus must be safely connected to multimedia systems. Follow instructions
described in this manual.
Replacing the AC fuse
WEEE
( W as te E l e c tric a l & E lec tr on ic Eq u ipm en t )
Correct Disposal of This Product
This marking shown on the product or its literature, indicates that it should not be disposed
with other household wastes at the end of its working life. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, please separate this from
other types of wastes and recycle it responsibly to promote the sustainable reuse of
material resources.
Household users should contact either the retailer where they purchased this product, or
their local government office, for details of where and how they can take this item for
environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the
purchase contract. This product should not be mixed with other commercial wastes for
disposal.
Caution: Laser product
This laser product is designated as Class 3R, wavelengths are 778nm, 800nm, 825nm and
850nm. Direct intrabeam viewing normally hazardous.
Section 1.

Unplug the AC power cord from the equipment

Locate the AC fuse on the rear of the unit

Replace only the AC fuse as indicated on the rear panel of the unit: 1 A fast blowing

Connect the power cord to the switcher and to the AC power source. Make sure
the switcher is working properly.
LASER RADIATION
AVOID EXPOSURE TO BEAM
CLASS 3R LASER PRODUCT
DVI-OPT-TX220-Pro, DVI-OPT-RX220-Pro
User's Manual
Page 3 / 57