Transmitter Features - Lightware DVI-OPT-TX220-Pro User Manual

1.4. Transmitter features

 Galvanic Isolation between source and display – Lightware fiber optical extenders are isolated
 Advanced EDID Management – User can emulate any EDID on the DVI-OPT-TX220-Pro's input,
 Supports all HDTV resolutions – 720p, 1080i, 1080p etc. without HDCP encoding. Unencrypted
 Single Fiber Technology – All of the high-speed TMDS data lanes are transmitted using only
 1.65 Gb/s channel transmission – Extends any DVI single link signal between 25 and 165 MHz
 Local Monitor Output – User can attach a local monitor to observe the video signal sent through
 Break-out LC connector (only on DVI-OPT-TX220-Pro) – A break-out LC fiber optical
 Front panel control – EDID address selection, EDID learning, firmware versions, laser
 RS-232 control – Input status, EDID Management, Terminal Window and hardware information
 Built-in universal power supply – The transmitter is equipped with a built-in universal power
 Remote power send (only on DVI-OPT-TX220-Pro) – The transmitter can send power to
Page 8 / 57
between transmitter and receiver to eliminate ground loop noise or HUM effects.
read out and store any monitor's EDID (attached to Local Monitor Output) in 49
internal memory locations.
signals up to 165 MHz pixel clock frequency - regardless of the resolution - are
passed through.
one multimode 50/125 fiber optical cable.
TMDS clock frequency conforming to DVI 1.0 standard.
the fiber optical cable. The resolution and clock frequency are the same on DVI
and fiber optical connectors, no internal scaling or conversion is applied.
connector allows users to transmit the signal of two transmitters in one Neutrik
OpticalCON Duo cable. See section
enable/disable functions are available on LCD based menu with navigation
buttons.
can be accessed in Lightware Device Controller software via RS-232 serial
connection.
supply, which accepts AC voltages from 100 to 240 Volts with 50 or 60 Hz line
frequency.
DVI-OPT-RX220-Pro if special hybrid fiber cable is used (type Neutrik 2M-4S75).
1.6 on page 10 for typical application.
Section 1. Introduction