Misfeed In The Paper Conveyor Unit - Kyocera KM-C850 Operation Manual

Misfeed in the paper conveyor unit

If a misfeed has occurred in the paper conveyor unit, perform the
following procedure to remove the jammed paper.
* The following display will be displayed after you pull out the
paper conveyor unit in step 2.
Inch specifications
aper misfeed.
JAM
Metric specifications
aper misfeed.
JAM
1
Open the front cover.
1.Open right side of transfer unit
and remove paper if inside.
2.Open right side of paper transfer and
remove any paper.
Also look in fuser & upper cover.
3.Release transfer unit lever.
4.Open transfer unit and remove
paper if inside.
5.Close front cover.
1.Remove paper if inside
on the conveying unit.
2.Conveying unit right, fuser unit left
and upper cover, remove paper if inside
3.Release transfer unit lever.
4. ull out transfer unit and remove
paper if inside.
5.Reset the unit and close front
cover unit.
Section 9 TROUBLESHOOTING
2
Operate the paper conveyor release lever and pull the
paper conveyor unit out towards you as far as it will go.
WARNING
High voltage is present in the charger section.
Take sufficient care when working in this area, as
there is a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take
sufficient care when working in this area, as there
is a danger of getting burned.
3
Push the green release lever (shown as (1) in the
illustration) down to the right, and remove the jammed
paper without tearing it.
(1)
NOTE
If the paper does happen to tear, remove any loose scraps
from inside the copier.
9-9