Troubleshooting) Ticicc. Cattcannt Foncoscsccuctctesenezacestactoneteneresresrasestceeseeneaee - Icom IC-T2H Instruction Manual

TROUBLESHOOTING T oS
lf your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
PROBLEM POSSIBLE CAUSE SOLUTION
No power comes on. ¢ The battery is exhausted. ¢ Charge the battery pack or place new dry cell bat-
(A slight current flows in the circuits even when the | teries in the battery case.
(Remove the battery pack if you will not be using the trans-
power is off.)
ceiver for a long time.)
Transmitting is impossible. | ¢ The battery is exhausted. ¢ Charge the batteries or place new dry cells in the sae 9,
battery case.
Frequency cannot be set. | * Memory mode, call channel or channel indication |* Push [a V] to select VFO mode; or, turn power on |pgs. 11
mode is selected. while pushing [A] + [0] to exit channel indication.
¢ The lock function is activated. ¢ Set [p L] down to deactivate the lock function.
Scan does not function. e The same frequencies are programmed into both | ¢ Program different frequencies.
scan edges.
¢ Only CH1 is programmed; or, all other memory | Program additional memories; or, cancel skip set-
channels are set as skip channels. tings for one or more channels.
[4] or [VW] keys do not |*Memory channels 1 and/or 2 are not pro- |* Program the memory channels or set to microphone | pgs.
function when using the | grammed and simple mode is selected. normal.
optional HM-75A.
Squelch does not open for | ¢ Tone squelch is activated. e Turn off the tone squelch. p. 26
received signals.
Some memory channels | e Some memories have been cleared or the num- |e Program the cleared memories or increase the num- | pgs.
cannot be selected. ber of active memories has been reduced. ber of active memory channels. 19, 30
ANI mode cannot be ac- | ANI mode can only be accessed through cloning. |* Set ANI operation using the CS-T2 CLONING SoFT- |p. 36
cessed. WARE.
Some functions are not | ¢ The desired function(s) has not been assigned to | Set the desired function(s) using Key Customize |p. 31
available. a key. mode.