Icom IC-T2H Instruction Manual page 39

© Calling group stations
@ Turn power on, then select the desired group channel.
@® Enter the 3-digit ANI code including the group code "D'—
the transceiver calls the desired station automatically.
e The transceiver transmits the pre-programmed selective code.
e When entering a 3-digit code, the transceiver automatically trans-
mits a group code after the 3rd digit is entered.
eWhen making group calls the transceiver does not ring and no
answer back connection code is received.
¢ You can make an announcement to your group immediately with-
out a connection procedure.
@ Push [PTT] in the regular way to communicate.
@ When your conversation is finished, while pushing [PTT],
push [#] to transmit a disconnect code.
© Group call code examples
[Example 1]
If "11D" is transmitted, transceivers with receive codes "110"
to "119" are called.
[Example 2]
If "1D3" is transmitted, transceivers with receive codes "103,"
"113,"..."183" and "193" are called.
47 NOTE: "DDD" transmits to all transceivers.
ANI OPERATION 11
© Waiting for a call
@ Turn power on, then select the de-
sired channel.
¢ The transceiver may be programmed
to start a scan at power on.
@ When you receive a selective call,
the transceiver "rings."
e Push [ANI CODE] to display the re-
ceive code.
@ Push [PTT] to send a connection code within 10 sec.
® While " «\" flashes, converse with the connected station.
© When your conversation is finished, you may receive a dis-
connect code.
¢ Transmitting a disconnect code from your side (push [PTT] + [#])
is also possible (except for group call receive).
¢" 3)" stops flashing.