Microtek ArtixScan DI 5240 Start Here Manual page 5

Using the Paper Stoppers
There are two types of Paper Stoppers at the output tray, which are designed to prevent the
outputs of stacked papers falling in a mess into the output tray after being scanned. Based
on the paper size in use, adjust either of Paper Stoppers to appropriate position to keep the
after-scanned outputs neatly in the output tray before scanning.
• Use the Paper Stopper (A) when the
scanned documents are smaller than
A4.
1) Load the paper to be scanned inside
the space between the stopper and
the output slot of the scanner.
2) Slide the Paper Stopper (A) until
the stopper touches the edge of the
paper.
If done, reload the papers to be
scanned into the feed tray to start
your scan.
NOTE: The position of the Paper Stopper (A)
on the tray must be equivalent to the length
of the paper. Incorrect positioning of the
Paper Stopper (A) will result in disorders and
mess for the after-scanned outputs.
• Use the Paper Stopper (B) when the
scanned documents are equivalent to
A4 or Letter size.
Lift up two Paper Stoppers (B) as the
direction shown in the graph.
• Ensure that the Paper Stoppers (B) are
closed when the scanned documents
are larger than A4 or Letter.
5
Align the paper against
the side of output slot
located at the bottom
of the scanner.
Be sure the stopper
is lightly against the
edge of the paper.
Open two
Paper Stoppers (B)
Close two
Paper Stoppers (B)