Microtek ArtixScan DI 5240 Start Here Manual page 4

Position Documents
The scanner supports scanning of document in various materials, such as A4 printouts,
insurance papers and legal documents. A stack of up to 75 sheets of papers 8 to 32 lb.
(30.08 to 120.32 g/m² ) can be fed in the scanner's Document Feed Tray at one time.
Paper sizes can range from 3.149" x 3.149" (80 mm x 80 mm) to 8.5" x 65" (216 mm x
1651 mm).
A. Into the ADF
1. Before loading the stack of papers into
the scanner's Document Feed Tray,
please fan the papers and then align the
top edges of the papers neatly.
2. Load the stack of papers into the
scanner's Document Feed Tray, with the
side to be scanned facing down and the
top edge facing toward the feeder.
Push the stack of papers into the tray
until the paper's edge touches the bottom
edge of the feeder.
WARNING: The document feeder is not
designed for scanning photos; doing so may
damage your originals. Microtek accepts no
responsibility for damage that may arise from
misuse of equipment.
3. Align the stack of originals with the
center of the Document Feed Tray by
sliding the two Guide Arms toward the
stacked papers if needed.
4. Use either of the Paper Stopper (A) or (B)
to keep a stack of papers stay neatly in
the output tray after the scan.
Paper Stopper (A)
Guide Arms
Paper Stopper (B)
4
Document Feed Tray
NOTE: For more details on how
to use the Paper Stopper, please
refer to the section "Using the
Paper Stoppers" at the next
page.