Installing The Sound Board Drivers; Installing The Cd Audio Driver - HP Kayak XA Installation Manual

1 Installing Your Multimedia Sound Kit
Installing the Accessory Software Under Windows NT 3.51

Installing the Sound Board Drivers

1 With Windows NT running, insert the HP Multimedia Sound CD in
the CD-ROM drive. (Insert the CD label side up; press the open/close
pushbutton to open and close the drawer.)
2 From the Program Manager, click on the File menu and click on Run.
Type d:\winnt\setup
that appear on the screen.
(The CD-ROM drive may be your E drive. In this case you would
enter e:\winnt\setup
Browse button in the Run dialog box, and then clicking on the
Drives drop-down list.)
3 When the driver has been installed, you see the 16-bit Audio Board
Setup window.
4 Click on the OK button.
5 Restart the computer.

Installing the CD Audio Driver

The audio driver (
(MCI) CD Audio)
computer. You can check whether it is and, if it is not, install it by
performing the following steps.
1 With Windows NT running, double-click on the Main program group
.
2 Double-click on the Control Panel icon
3 Double-click on the Drivers icon
4 Check whether the driver
Installed Drivers list. If it is, click on the Cancel button to exit the
installation procedure. If the driver is not displayed, continue from
step 5.
5 Click on Add.
6 Click on
(MCI) CD Audio
7 Restart the computer.
8 English
and then follow the instructions
. You can check by clicking the
may be already installed on your
.
.
is displayed in the
(MCI) CD Audio
, then click on OK.