Installing the Accessory Software Under OS/2 Warp
Under OS/2 Warp, you need to install the CD-ROM driver and the
sound board driver, as follows. Install the CD-ROM driver first.
Installing the CD-ROM Driver
OS/2 Warp contains its own driver software for the CD-ROM.
1 With OS/2 running, double-click on the OS/2 System folder and then
double-click on the System Setup folder.
2 Double-click on the Selective Install icon.
3 Click on the CD-ROM Device Support icon and, from the list of
devices, select
Non-listed IDE CD-ROM
4 Click on OK at the System Configuration window.
5 At the OS/2 Setup and Installation window, make sure Multimedia
Software Support is selected, and click on Install.
6 If a location such as
location, click on Install. (Your system is preset to locate the driver.)
Otherwise, insert the OS/2 Warp Program Disk if you have the CD
and if the CD-ROM driver is already installed. Leave
entered as the location. Click Install.
Otherwise, enter A: and click on Install, and insert the OS/2 Warp
installation floppy disk as instructed.
7 When installation is complete, shut down and restart your system.
1 Installing Your Multimedia Sound Kit
Installing the Accessory Software Under OS/2 Warp
C:\disketts\os2v3
and click on OK.
is displayed as the driver
D:\OS2IMAGE
English 13