Grizzly G1140 Owner's Manual page 27

table height: to adjust the table height, loosen
the leadscrew lock handle and stabilizing lock bolt
(figure 28). turn the handwheel and position the
work table to the desired height, then retighten the
lock handle and lock bolt.
leadscrew lock handle
figure 28. table height controls.
End table: to adjust the end table height, loosen
the thumb screws, position the table, then re-
tighten the thumb screws, as shown in figure
29. When using the end roller for curved sanding,
we recommend you use the center portion of the
roller to assure proper belt tracking. this also
prevents the edge of the workpiece from becom-
ing tapered.
thumb Knob
figure 29. end table.
g1140/g1531 6" X 80" edge sander
belt tracking and tension: to adjust the track-
ing, loosen the belt tension lock knob, move the
tension lever to the closed position, turn the belt
tracking knob to adjust the belt height, then tight-
en the belt tension lock knob.
Belt tension
lock Bolt
stablizing
lock Bolt
figure 30. Belt tracking and tension controls.
platen tilt (Model G1140 Only): to tilt the
platen, loosen the table tilt lock handle and lock
bolt shown in figure 31, carefully tilt the platen
assembly (figure 32), then retighten the lock
handle and lock bolt. after returning the platen
assembly to its upright position tighten the lock
handle and lock bolt.
lock handle
Belt tracking
lock Knob
Knob
lock Bolt
figure 31. platen tilt lock bolt.
figure 32. platen tilted to 90 ˚ .
tension
lever
-25-