Grizzly G1140 Owner's Manual page 19

8.
Move the tension lever back to its tensioned
position, as shown in figure 7. Belt pre-
tracking and tracking are covered on page 18
& page 19.
figure 7. sanding belt installed.
9. position the dust hood approximately 1" away
from the main roller and fasten to the sander
using the two pre-installed
and flat washers, as shown in figure 8.
2 x
figure 8. dust hood installed.
g1140/g1531 6" X 80" edge sander
/ "-18 hex bolts
5
16
10. install the idler roller guard onto the left end
of the sander with the preinstalled
knob and / " flat washer, as shown in figure
1
4
9.
idler roller
guard
lock Knob
Flat Washer
figure 9. idler roller guard installed.
1 / "-20 lock
4
-17-