Grizzly G1140 Owner's Manual page 23

figure 16. table bracket top secured.
10. Measure the distance between the table
bracket and stand, checking that the bracket
is parallel to the stand, as shown in figure
17.
— if the bracket is not parallel to the stand,
loosen the hex nuts on the vertical brace
and adjust the table bracket-stand distance
until it is equal.
— if the bracket is still not parallel, remove
the vertical brace, thread the horizontal
brace in or out an appropriate amount, and
reinstall the vertical brace. Check the table
bracket-stand distance and adjust until it is
equal.
Bracket-stand
distance
figure 17. Checking table bracket for
parallelism.
g1140/g1531 6" X 80" edge sander
11. once the table bracket is parallel to the stand,
tighten the horizontal brace jam nut and the
hex bolt and hex nuts that hold the vertical
brace in place.
12. attach each table trunnion to the table brack-
et with a / '' flat washer and lock handle, as
3
8
shown in figure 18. the trunnion with the
scale attaches to the left side.
table trunnions
figure 18. table trunnions installed.
13. leaving the table trunnion lock handles
slightly loose, secure the work table to the
trunnions using the two
'' flat washers, as shown in figure 19.
and /
5
16
adjust the table so it is approximately
/ '' from the sanding platen, then tighten the
3
16
mounting bolts.
figure 19. Work table installed.
Note: You can use an
1
gauge to set the distance between the table and
sanding belt.
Flat Washer
lock handle
/ ''-18 x 1'' hex bolts
5
16
1 / '' to
8
2x
/ " or / " hex wrench as a
3
8 16
-21-