Configuring Msdp; Understanding Msdp - Cisco WS-C3750-48PS-S Software Configuration Manual

Configuring MSDP

This chapter describes how to configure the Multicast Source Discovery Protocol (MSDP) on the
Catalyst 3750 switch. The MSDP connects multiple Protocol-Independent Multicast sparse-mode
(PIM-SM) domains.
MSDP is not fully supported in this software release because of a lack of support for Multicast Border
Gateway Protocol (MBGP), which works closely with MSDP. However, it is possible to create default
peers that MSDP can operate with if MBGP is not running.
To use this feature, the stack master must be running the enhanced multilayer image (EMI). Unless
otherwise noted, the term switch refers to a standalone switch and to a switch stack.
For complete syntax and usage information for the commands used in this chapter, refer to the Cisco IOS
Note
IP Command Reference, Volume 3 of 3: Multicast, Release 12.2.
This chapter consists of these sections:
•
•
•

Understanding MSDP

MSDP allows multicast sources for a group to be known to all rendezvous points (RPs) in different
domains. Each PIM-SM domain uses its own RPs and does not depend on RPs in other domains. An RP
runs MSDP over the Transmission Control Protocol (TCP) to discover multicast sources in other
domains.
An RP in a PIM-SM domain has an MSDP peering relationship with MSDP-enabled devices in another
domain. The peering relationship occurs over a TCP connection, primarily exchanging a list of sources
sending to multicast groups. The TCP connections between RPs are achieved by the underlying routing
system. The receiving RP uses the source lists to establish a source path.
78-16180-02
Understanding MSDP, page 37-1
Configuring MSDP, page 37-4
Monitoring and Maintaining MSDP, page 37-19
C H A P T E R
Catalyst 3750 Switch Software Configuration Guide
37
37-1