Cisco WS-C3750-48PS-S Software Configuration Manual page 815

Network switch
Table of Contents

Advertisement

Chapter 36
Configuring IP Multicast Routing
Beginning in privileged EXEC mode, follow these steps to manually configure the address of the RP.
This procedure is optional.
Command
Step 1
configure terminal
Step 2
ip pim rp-address ip-address
[access-list-number] [override]
Step 3
access-list access-list-number {deny |
permit} source [source-wildcard]
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
To remove an RP address, use the no ip pim rp-address ip-address [access-list-number] [override]
global configuration command.
This example shows how to configure the address of the RP to 147.106.6.22 for multicast
group 225.2.2.2 only:
Switch(config)# access-list 1 permit 225.2.2.2 0.0.0.0
Switch(config)# ip pim rp-address 147.106.6.22 1
78-16180-02
Purpose
Enter global configuration mode.
Configure the address of a PIM RP.
By default, no PIM RP address is configured. You must configure the IP
address of RPs on all routers and multilayer switches (including the RP).
If there is no RP configured for a group, the switch treats the group as
dense, using the dense-mode PIM techniques.
A PIM device can be an RP for more than one group. Only one RP address
can be used at a time within a PIM domain. The access-list conditions
specify for which groups the device is an RP.
For ip-address, enter the unicast address of the RP in dotted-decimal
notation.
(Optional) For access-list-number, enter an IP standard access list
number from 1 to 99. If no access list is configured, the RP is used for
all groups.
(Optional) The override keyword means that if there is a conflict
between the RP configured with this command and one learned by
Auto-RP or BSR, the RP configured with this command prevails.
Create a standard access list, repeating the command as many times as
necessary.
For access-list-number, enter the access list number specified in
Step 2.
The deny keyword denies access if the conditions are matched. The
permit keyword permits access if the conditions are matched.
For source, enter the multicast group address for which the RP should
be used.
(Optional) For source-wildcard, enter the wildcard bits in dotted
decimal notation to be applied to the source. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3750 Switch Software Configuration Guide
Configuring IP Multicast Routing
36-13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3750

Table of Contents