Source Ports - Cisco WS-C3750-48PS-S Software Configuration Manual

Understanding SPAN and RSPAN
•
•
The default configuration for local SPAN session ports is to send all packets untagged. SPAN also does
not normally monitor bridge protocol data unit (BPDU) packets and Layer 2 protocols, such as Cisco
Discovery Protocol (CDP), VLAN Trunk Protocol (VTP), Dynamic Trunking Protocol (DTP), Spanning
Tree Protocol (STP), and Port Aggregation Protocol (PAgP). However, when you enter the
encapsulation replicate keywords when configuring a destination port, these changes occur:
•
•
Therefore, a local SPAN session with encapsulation replicate enabled can have a mixture of untagged,
802.1Q, and ISL tagged packets appear on the destination port.
Switch congestion can cause packets to be dropped at ingress source ports, egress source ports, or SPAN
destination ports. In general, these characteristics are independent of one another. For example:
•
•
•
In some SPAN configurations, multiple copies of the same source packet are sent to the SPAN
destination port. For example, a bidirectional (both Rx and Tx) SPAN session is configured for the Rx
monitor on port A and Tx monitor on port B. If a packet enters the switch through port A and is switched
to port B, both incoming and outgoing packets are sent to the destination port. Both packets are the same
(unless a Layer-3 rewrite occurs, in which case the packets are different because of the packet
modification).

Source Ports

A source port (also called a monitored port) is a switched or routed port that you monitor for network
traffic analysis. In a local SPAN session or RSPAN source session, you can monitor source ports or
VLANs for traffic in one or both directions. The switch supports any number of source ports (up to the
maximum number of available ports on the switch) and any number of source VLANs (up to the
maximum number of VLANs supported). However, the switch supports a maximum of two sessions
(local or RSPAN) with source ports or VLANs and you cannot mix ports and VLANs in a single session.
A source port has these characteristics:
•
•
Catalyst 3750 Switch Software Configuration Guide
27-6
Transmit (Tx) SPAN—The goal of transmit (or egress) SPAN is to monitor as much as possible all
the packets sent by the source interface after all modification and processing is performed by the
switch. A copy of each packet sent by the source is sent to the destination port for that SPAN session.
The copy is provided after the packet is modified.
Packets that are modified because of routing—for example, with modified time-to-live (TTL),
MAC-address, or QoS values—are duplicated (with the modifications) at the destination port.
Features that can cause a packet to be dropped during transmit processing also affect the duplicated
copy for SPAN. These features include IP standard and extended output ACLs and egress QoS
policing.
Both—In a SPAN session, you can also monitor a port or VLAN for both received and sent packets.
This is the default.
Packets are sent on the destination port with the same encapsulation—untagged, IEEE 802.1Q, or
Inter-Switch Link (ISL)—that they had on the source port.
Packets of all types, including BPDU and Layer 2 protocol packets are monitored.
A packet might be forwarded normally but dropped from monitoring due to an oversubscribed SPAN
destination port.
An ingress packet might be dropped from normal forwarding, but still appear on the SPAN
destination port.
An egress packet dropped because of switch congestion is also dropped from egress SPAN.
It can be monitored in multiple SPAN sessions.
Each source port can be configured with a direction (ingress, egress, or both) to monitor.
Chapter 27 Configuring SPAN and RSPAN
78-16180-02