Message
Can't Solve!
•
A Solve calculation could not obtain
Adjust initial
a solution within the specified range.
value or
bounds. Then
try again
No Variable
No variable specified within a graph
function being used for Dynamic
Graph.
No variable within a Solve equation.
Conversion
•
Attempting to use the unit
ERROR
conversion command to convert
between two units in different
categories.
•
Executing a conversion calculation
using the same command twice in a
conversion expression.
Com ERROR
•
Problem with cable connection or
parameter setting during program
data communications.
Transmit
•
Problem with cable connection
ERROR
or parameter setting during data
communications.
Receive
•
Problem with cable connection
ERROR
or parameter setting during data
communications.
Memory Full
•
Memory of receiving unit
became full during program data
communications.
Invalid Data
•
Attempting to send data of a
Size
size that is not supported by the
receiving device.
Example: Attempting to send a
matrix with more than 256 lines from
the fx-9750G
Invalid Data
•
Attempting to send data with a data
Number
number that is not supported by the
receiving device.
Example: Attempting to send
List 7 from the fx-9750G
older model that supports only up
to List 6.
Meaning
II
to an older model.
II
to an
-3
Countermeasure
•
Change the specified range.
•
Correct the input expression.
Specify a variable for the graph
function.
Input a Solve equation that
includes a variable.
•
In a conversion expression,
specify two different commands
that are in the same category.
•
Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
•
Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
•
Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
•
Delete some data stored in the
receiving unit and try again.
•
Make sure the data being sent is
of a size that is supported by the
receiving device.
•
Specify a data number supported
by the receiving device when
sending data.