Casio FX-7400GII - SOFTWARE VERSION 2-00 User Manual page 273

• The following describes each of the setting items for this screen.
Item
1Var XCell
1Var Freq
2Var XCell
2Var YCell
2Var Freq
3. If you want to change the cell range, use
you want to change and the input the new cell range.
• To input the colon (:), press
• To edit the currently input cell range, press
XCell, and 2Var YCell) or
4. After configuring the required settings, press
STAT Mode and S
In both the STAT mode and the S
function menu and statistical/regression calculation functions are on the CALC function menu.
The structures of these menus and their submenus are the same in the STAT mode and the
S SHT mode. For details about each menu item, refer to the pages referenced in the table
•
below.
For information about
this menu item:
{GRPH} - {GPH1}
{GRPH} - {GPH2}
{GRPH} - {GPH3}
{GRPH} - {SEL}
{GRPH} - {SET}
{CALC} - {1VAR}
{CALC} - {2VAR}
{CALC} - {REG}
{CALC} - {SET}
The cell range data specified here is used for variable
Frequency values when performing single-variable statistical
calculations.
The cell range data specified here is used for variable
and Frequency values when performing paired-variable statistical
calculations.
(:).
(CELL) (in the case of 1Var Freq and 2Var Freq).
SHT Mode Function Menu Correspondence Table
•
SHT mode, statistical graph functions are on the GRPH
•
Refer to:
"Changing Graph Parameters" (page 6-1)
"Graph draw/non-draw status" (page 6-3)
"Changing Graph Parameters" (page 6-1)
"General graph settings"(page 6-1)
"To display the general graph settings screen"(page 6-2)
"General Graph Settings Screen Operations" (page 9-16)
"Single-Variable Statistical Calculations" (page 6-15)
"Paired-Variable Statistical Calculations" (page 6-15)
"Regression Calculation" (page 6-16)
"Using the Statistical Calculation Data Range Specification
Screen" (page 9-18)
9-19
Description
and to move the highlighting to the item
(CELL) (in the case of 1Var XCell, 2Var
or .
x
and
x y
, variable ,