Casio CW-K85 User Manual page 50

Symptom Possible Cause
I can't get a The COMPUTER
connection
LINK button has not
between been pressed.
the printer
The USB cabled is not
and a
connected properly.
computer.
The printer is turned
off.
The USB driver is not
installed correctly.
Though the USB driver
is installed correctly,
data communication is
not possible for some
reason.
The printing
The ink ribbon is used
operation is
up.
finished
normally,
but nothing
is printed.
The printed
The color of the final
color is
printout is affected by
different
both the color of the
from the ink
ink ribbon and the
ribbon
color of the disc you
color.
are printing on.
48
E
Recommended Action
Press the COMPUTER LINK
button to establish a connec-
tion.
Re-connect the cable properly.
Press to turn on the
printer.
Unplug the USB cable and the
plug it back in again.
Try using a different USB port
on your computer, or try using
a different USB cable.
Load a new ink ribbon
cassette (option). (page 15)
Try using a lighter color disc or
a darker color ink ribbon.
Symptom Possible Cause
Improper alignment of
The printing
is not the disc when it is
placed in the printer.
positioned
correctly on
the disc.
The disc The power cord plug
or the AC adaptor is
stops part
not plugged in as far
way
through as it will go.
printing.
The printer is
malfunctioning.
Battery power is low or
the wrong type of
batteries are loaded in
the printer.
I cannot
The cassette cover is
insert a not closed properly.
disc into
the printer.
The disc is not
Printing will
positioned correctly in
not start.
the printer.
Recommended Action
Use the positioning guide
when aligning the disc. (page
22)
Correctly connect the power
cord and the AC adaptor.
(page 9)
If you cannot easily remove
the disc from between the
print head and roller, Remove
the disc from the printer as
shown on page 8.
Use the AC adaptor to power
the printer, or replace the
current batteries with a fresh
set of AA-size alkaline
batteries.
Close the cassette cover
properly and insert the disc.
(page 9)
Remove the disc and then re-
insert it straight into the left
side of the slit along the top of
the printer. (page 21)