Advertisement
Quick Links
Rehearsal Resource Center Assembly Instructions 121B021.
Make sure anyone assembling, installing or
using this product has read and understands
these instructions.
Contents
Required Tools 2
Supplied Hardware 2
Visit the Rehearsal Resource Center web page at wengercorp.com for more information.
Note: Please read and understand these instructions before proceeding
Note: If you need additional information, contact Wenger Corporation using the information below
©Wenger Corporation 2024
Wenger Corporation, 555 Park Drive, P O Box 448, Owatonna, Minnesota 55060-0448
Questions? Call USA: (800) 4WENGER (493-6437) • Worldwide: +1-507-455-4100 • wengercorp com
Basic Instructions only!
For more detailed product information, refer to the
CAUTION
for Rehearsal Resource Center
Failure to comply with Warnings and Cautions in
this document or on the equipment can result in
damage to property or injury.
Parts List 2
Assembly 2
Printed in USA 2024-10
Assembly Instructions
Folio Box Option
CAUTION
Part #121B115-02
Advertisement
Related Manuals for Wenger Folio Box Option
Summary of Contents for Wenger Folio Box Option
- Page 1 Visit the Rehearsal Resource Center web page at wengercorp.com for more information. Note: Please read and understand these instructions before proceeding Note: If you need additional information, contact Wenger Corporation using the information below ©Wenger Corporation 2024 Printed in USA 2024-10...
- Page 2 Flat Panel Folio Box Assembly This page is intentionally blank. Before starting the folio box option assembly, do the following 1 Read and understand this assembly instruction 2 Remove all items from the shipping cartons Make sure that all parts are present...
- Page 3 Assembly (continued) To assemble a folio box, do as follows 1 Attach the folio box backstop (3) to one folio box shelf support (6) with two truss head screws (7) Pilot holes on the end of the side panel locate the position of the backstop 2. Align the clearance holes in two folio box flat panels (4) with the pilot holes in two folio box shelf supports (6) Make sure that the shelf support slots face the inside of the box 3. Using a phillips screwdriver, fasten the flat panels (4) to the shelf supports (6) by screwing sixteen...
- Page 4 Assembly (continued) 5 Install the folio boxes in a unit assembly as follows: a Remove the protective backing on a bumper (2) and place the bumper (2), with the adhesive side against the mid-shelf surface, directly below the pass through door lock at the back of the unit assembly mid-shelf as shown below b Place the folio box assemblies on the mid-shelf with a side of the right folio box against the right side panel of the left curved unit assembly (left side for the right curved unit assembly)
Need help?
Do you have a question about the Folio Box Option and is the answer not in the manual?
Questions and answers