Port Oc-192C/Stm-64 Pos/Rpr Xfp Spa Optical Transceiver Modules, Connectors, And Cables - Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
Table 3-31
Table 3-31
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
ACTIVE
STATUS
1-Port OC-192c/STM-64 POS/RPR XFP SPA Interface Specifications
The framer processes incoming and outgoing SONET or SDH frames. The framer operates at
OC-192c/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP]),
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA interface is compliant with the following RFCs:
•
•
1-Port OC-192c/STM-64 POS/RPR XFP SPA Optical Transceiver Modules,
Connectors, and Cables
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA uses a single-mode, 9.95 Gbps, OC-192c optical fiber
(SONET STS-192c or SDH STM-64) optical transceiver module for SONET and SDH connection to the
network.
OL-14126-12
describes the 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs.
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking SRP mode mismatch alarm is indicated.
Off Off
Green On
Amber On
Off Off
Green On
Amber On
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-through mode.
Port is in pass-through mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without any alarms.
Port is enabled by software, and there is at least one alarm (LOS,
LOF, RDI, and so on).
Port is not enabled by software.
Port is enabled by software, and loopback is off.
Port is enabled by software, and loopback is on.
SPA power is off.
SPA is ready and operational.
SPA power is on and good, and the SPA is being configured.
3-53