Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual page 148

SIP Installation and Removal
Tighten the locking thumbscrews on both sides of the SIP.
Step 4
Connect all cables to each SPA.
Step 5
To remove a SIP, refer to
Step 1 To remove the SIP, first disconnect all cables from each SPA.
Loosen the locking thumbscrews on both sides of the SIP.
Step 2
Slide the SIP out of the router slot. If you are removing a blank filler plate, pull the blank filler plate
Step 3
completely out of the router slot.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
5-10
Figure 5-2 and do the following:
Chapter 5 Installing and Removing a SIP
OL-14126-12