Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual page 135

Chapter 4 Preparing to Install a SIP or a SPA
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool. Statement 1035
Never install telephone jacks in wet locations unless the jack is specifically designed for
Warning
wet locations. Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been
Warning
disconnected at the network interface. Statement 1037
Warning Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning. Statement 1038
Warning To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
OL-14126-12
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
Safety Guidelines
4-7