Cisco Asr1000-Sip40 Overview - Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual

Chapter 2 Overview: Cisco ASR 1000 Series Aggregation Services Routers SIPs
Table 2-5
Description
Relative humidity
Storage temperature

Cisco ASR1000-SIP40 Overview

The Cisco ASR1000-SIP40 supports up to 40 Gbps total bandwidth for the four SPA bays and 46 Gbps
sustained through carrier card when utilizing two four-link 6.25GHz ESIs. Following are the features of
the Cisco ASR1000-SIP40:
•
•
•
•
•
•
•
•
The Cisco ASR1000-SIP40 supports four half-height SPAs, two full-height SPAs, and a combination of
Note
two half-height and one full-height SPAs. The Cisco ASR1000-SIP40 does not support double-wide
SPAs, and double-high SPAs having two connectors.
The Cisco ASR1000-SIP40 runs on the Cisco ASR1006 and the Cisco ASR 1013 routers for Cisco IOS
XE Release 3.1S. The Cisco ASR 1000-SIP40 support on Cisco 1004 Routers was added in Cisco IOS
XE Release 3.2S. The LEDs on the modules are the same for both the Cisco ASR1000-SIP10 and Cisco
ASR1000-SIP40.
Warning The Cisco ASR1000-SIP40 is not supported on the Cisco ASR 1002, Cisco ASR 1002-F routers, or Cisco
ASR 1004 chassis in Cisco IOS XE Release 3.1S. The Cisco ASR1000-SIP40 is supported only with RP-2
or later RPs (not supported with RP-1). Also, the ASR1000-SIP40 is primarily supported with ESP-40. If
the system has RP-1 or ESP-10 or ESP20 then you need to first upgrade the RP-1 to RP-2 followed by
upgrading ESP10 or ESP20 to ESP-40 and then installing the ASR1000-SIP40 into the system.
The following sections describe the Cisco ASR1000-SIP40:
•
•
OL-14126-12
Cisco ASR1000-SIP10 Physical Specifications (continued)
Supports 40 Gbps of non oversubscribed throughput.
Compatible with existing and future SPAs, ESPs, and RPs.
Supports online-insertion-and-removal (OIR) of all SIP-10 SPAs and Cisco ASR1000-SIP40.
Provides higher port density support of 48 point dual priority, and 96 point single priority.
Enables enhanced QoS and timestamp support.
Performs ingress packet prioritization based on Layer 2 or Layer 3 headers.
Enables the flow-control of the SPAs.
Distributes line clocking reference from a single SPA to the RPs.
Cisco ASR1000-SIP40 LEDs
Cisco ASR1000-SIP40 Physical Specifications
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
Cisco ASR 1000 Series SPA Interface Processor Overview
Specifications
Operating Humidity Nominal—5% to 85% noncondensing
Operating Humidity Short Term—5% to 90% noncondensing
–40F to 158F (–40°C to 70°C)
2-9