Using Debug Commands - Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual

Chapter 7 Troubleshooting the Installation

Using debug Commands

The debug hw-module subslot command is intended for use by Cisco technical support personnel. For
more information about the debug hw-module subslot command, see the Cisco ASR 1000 Series
Aggregation Services Routers SIP and SPA Software Configuration Guide.
Because debugging output is assigned high priority in the CPU process, it can render the system
Caution
unusable. For this reason, use debug commands only to troubleshoot specific problems or during
troubleshooting sessions with Cisco technical support staff. Moreover, it is best to use debug commands
during periods of lower network traffic and fewer users. Debugging during these periods decreases the
likelihood that increased debug command processing overhead will affect system use.
Packing a SPA for Shipment
This section provides step-by-step instructions for packing a SPA for shipment. Before beginning this
procedure, you should have the following original Cisco packaging materials:
•
•
•
For information on removing a SPA, see the
Note
The Cisco original packaging is to be used for the shipment of all SPAs and cable management brackets.
Caution
Failure to properly use Cisco packaging can result in damage or loss of a product.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card.
Caution
See
These instructions assume that the SPA and cable management brackets have been removed from the
Note
router according to the recommended procedures specified in this guide.
To pack a SPA for shipment, see
Open the clamshell container and place the SPA into the appropriate cavity.
Step 1
Always handle the SPA by the carrier edges and handle; never touch the SPA components or connector
Caution
pins.
Close the clamshell container.
Step 2
OL-14126-12
Clamshell inner container
Foam cushion (2)
Exterior carton
Preventing Electrostatic Discharge Damage, page 4-8
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
"SPA Installation and Removal" section on page
for information about preventing ESD.
Figure 7-1 and perform the following steps:
Using debug Commands
6-2.
7-17