Manual Tuning; To Search For A Station Quickly (Auto Search); To Change The Am Tuning Interval - Aiwa CX NMA545 Operating Instructions Manual

1
2
TUNER
BAND
Press TUNER BAND repeatedly to select the
desired band.
r-
FM — AM
When TUNER BAND is pressed while the power is off, the
power is turned on directly.
Press + DOWN or - UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, (l@Il] is displayed.
TUNE [(lam]]
When an FM stereo broadcast contains noise
,-:-
,,:= ~ ,,
Press MONO on the remote control so that "MONO appears on ~g$~
the display.
*
&
1$ t.
Noise is reduced. althouah recerXion is monaural.
#~&$
@
To restore stereo receptfin, repeat the above so that "MONO ~" ~~
disappears.
3,,,. ',>
$&&a $
,'$~
. .
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If Z
you use this unit in an area where the frequency allocation system o
is 9 kHz/step, change the tuning interval.
I
-,,
,g =?,?
Press POWER while pressing -.
yi
/g ,r
To reset the interval, repeat this procedure.
w
~=, &
,,
m
~:gj
if VI!
1!
* ??
When the AM tuning interval is changed, all preset stations are "
cleared. The preset stations have to be set again.
4
&
To search for a station quickly (Auto Search)
Keep + DOWN or ~ UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press ++ DOWN or -
UP.
The Auto Search may not stop at stations with very weak
signals.
ENGLISH 11