Rockwell Automation Allen-Bradley PowerFlex 755T Installation Instructions Manual

Installation Instructions
Original Instructions
PowerFlex 755T Frame 6L DC Bus Bar Conversion Kit
Catalog Numbers 20-750-DCBS1-F6L
Topic
Product Advisories
Required Tools
Frame 6L DC Bus Bar Conversion Kit Contents (Cat. No. 20-750-DCBS1-F6L)
Frame 6L DC Bus Bar Conversion Kit Installation
Frame 6L Drive and Bus Supply Power Terminal Identifications
Additional Resources
Summary of Changes
This publication contains new and updated information as indicated in the following table.
Topic
Frame 6L content updated.
Product Advisories
ATTENTION: Only qualified personnel, who are trained and approved to install PowerFlex® 755T products and familiar with associated machinery,
should plan or implement the installation, startup, and subsequent maintenance of the system. Failure to comply can result in personal injury and/or
equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive has been removed before performing any steps of these instructions.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the bus capacitors has completely discharged before performing any work on
the drive. After removing power to the drive, wait 5 minutes for the bus capacitors to discharge. Remove the front cover of the drive. Measure the DC
bus voltage at the DC+ TESTPOINT and DC- TESTPOINT sockets on the front of the drive (see drawing on
ATTENTION: HOT surfaces can cause severe burns. Do not touch the heatsink surface during operation of the drive. After disconnecting power allow
time for cooling.
ATTENTION: The information that is contained in this publication is merely a guide for proper installation. Rockwell Automation®, Inc. cannot assume
responsibility for the compliance or the noncompliance to any code, national, local or otherwise for the proper installation of this drive or associated
equipment. A hazard of personal injury and/or equipment damage exists if codes are ignored during installation.
ATTENTION: This product contains Electrostatic Discharge (ESD) sensitive parts and assemblies. Static control precautions are required when you
install these assemblies. Component damage can result if ESD control procedures are not followed. If you are not familiar with static control
procedures, reference any applicable ESD protection handbook.
Page
1
2
2
2
3
9
Page
Throughout
page 3). The voltage must be zero.