General Warnings - BWT AQA drink DROP General Instructions Manual

GLOSSARY
MANUFACTURER: this term is used to identify the manufacturer of the tap, with his name on the EC Declaration of Conformity
any person in the vicinity of the device
EXPOSED PERSON:
this term identifies all dangers that are not obvious and cannot be eliminated at the tap design stage
RESIDUAL RISKS:

GENERAL WARNINGS

ATTENTION:
Read this manual carefully before using the device .
The technical information contained in this manual is the property of BWT ; Reproduction of this manual, even partial, is
prohibited
Conserve the manual carefully and deliver it to the new owner in case of transfer of the appliance;
Make sure that the appliance has not been damaged during transport. Packaging materials, being potential sources of danger,
must not be left within the reach of children, they must also be disposed of in compliance with current regulations.
Not use damaged appliances. In case of abnormal operation (short circuits, sudden shutdowns, water leaks, etc.) turn off the appliance,
close the shut-off valve of the feed water of the appliance and remove the power supply, finally call the authorized technical service
center. The manufacturer rejects any responsibility in case of modifications and errors of electrical and hydraulic connection, caused
by non-compliance with the instructions in the installation manuals of the equipment. Circumstances of use of the equipment for
purposes other than those intended are prohibited. FAILURE TO COMPLY WITH THESE INDICATIONS DETERMINES THE
IMMEDIATE LOSS OF THE GUARANTEES.
SAFETY WARNINGS
ATTENTION:
Read the instruction manual carefully and store it carefully in a dry, protected place; keep it close to the appliance so that it can be
consulted if necessary.
Do not leave the material used for packaging (box, bag, staples, etc.) within the reach of children. It is advisable to keep the
packaging for future reuse; otherwise dispose of the materials according to the regulations in force.
If the appliance is damaged or has
disassemble or tamper with it. You should contact your dealer directly for repair.
Place the appliance on the ground on a flat and stable
rain, frost, etc.).
Do not overlap the appliance with other appliances.
Place the appliance away from
Installation, extraordinary maintenance and repairs must be carried out only and exclusively by qualified and specialized
personnel authorized by the manufacturer; always contact your dealer or authorized technical assistance center of BWT
The installation must be carried out by qualified
provisions of Ministerial Decree No. 37 of 22 January 2008 relating to the reorganization of the provisions on the installation of
systems inside buildings.
ATTENTION: The feed water of the appliance must be exclusively drinking water, with characteristics that meet the limits set by
Legislative Decree 31/2001, relating to the quality of water intended for human consumption.
It is absolutely forbidden to connect the appliance to sources of water other than drinking. Do not use the appliance to dispense
volumes of water greater than those indicated in the technical data or at pressures below 2.5 or greater than 4 bar.
4 GENERAL INSTRUCTIONS
AQA DRINK DROP
visible defects or malfunctions, it is recommended
surface;
heat sources .
personnel able to issue a regular declaration of conformity in accordance with
Rev.0 – 07/2024
not to
in a suitable and weathered place (sun,
use it and not to attempt to
the