BWT AQA drink DROP General Instructions Manual page 12

DECOMMISSIONING AND SCRAPPING EQUIPMENT
TEMPORARY DECOMMISSIONING
The machine can remain unused or be switched off for a long time. In these cases, when you want to put it back into
you must observe some requirements:
In the event that the dispenser has been switched off for more than 24 hours, dispense at least 5 liters.
A)
and water quality);
If no water has been dispensed for more than 24 hours, dispense at least 2 liters of water before consumption;
B)
Sanitize the dispenser as needed;
C)
If the dispenser is equipped with filters or other water
D)
instructions ;
The dispenser must be managed in full compliance with hygiene regulations to guarantee the quality of the product dispensed.
E)
FINAL DECOMMISSIONING FOR SCRAPPING
When the device is put out of use, it must be rendered unusable by removing the plug from the socket and cutting the power
plug of the cable. Disconnect the appliance from the water supply line.
The materials constituting the device do not require special treatments other than to be divided and grouped according to the
type (eg ferrous, plastics, rubber, etc.).
Follow the regulations in force in the municipality and/or country where the appliance will be scrapped. The waste must be
disposed of in accordance with current national practice, possibly using a recognised and authorised company for this service, or
using municipal waste collection centres.
GUARANTEE
For this equipment, the statutory warranty terms apply. Exclusion
of warranty rights
) Failure to comply with the requirements for assembly and the duties
) Failure of the appliance or poor performance caused by an incorrect combination of materials, a supply
or deposits of iron and manganese, or for damage resulting from these reasons, BWT assumes no liability.
) The manufacturer declines all responsibility in the event of changes and errors in electrical and hydraulic connection, determined
failure to comply with the instructions in the manuals for installing or using the equipment under conditions other than those
for which it was designed.
) Failure to check and/or replace parts subject to wear will automatically invalidate the warranty.
DISPOSAL WARNINGS
The electrical and electronic components used in support of this equipment must not be disposed of with other waste
at the end of their life but collected at the end of their life cycle .
Proper separate collection helps to avoid potential negative consequences for the environment and health and
encourages the reuse and recycling of the materials of which the equipment is composed. The symbol shown on the
product or on the packaging and in these instructions for use indicate that the electrical and electronic components used
with this equipment must be subject to separate collection in accordance with Legislative Decree 14/03/14, no. 49
implementing Directive 2012/19/EU on waste electrical and electronic equipment (WEEE).
The user is invited to separate the electrical and electronic components from other types of waste by delivering it to the
appropriate authorised collection centres in accordance with local regulations or, if coming from a household, by handing it
over to the distributor when purchasing a new appliance of an equivalent type. For the management of the recovery/disposal
of its electrical and electronic equipment BWT adheres to a collective system in the form of a consortium according to articles
2602 et seq. of the civil code.
treatment systems, replace them in accordance with the manufacturer's
of the operator
Rev.0 – Issue 07/2024
water (as needed
will result in the exclusion of warranty rights
of corrosive products
A Q A Drink Drop.
operation,