Reset To Factory Defaults - ETC Echoflex Elaho DMX Scene Controller Installation Manual

Echoflex Installation Guide
DMX Scene Controller
Basic
Set the switch to Basic configuration mode to apply the following
behaviors to the DMX Scene Controller:
• Preset snapshot record and recall for all 512 DMX addresses, for up
to 32 presets
• 2 second preset fade time
• Zone patch data is not applied, therefore no zones will be
individually controllable
• Space Raise/Lower as well as any other space intensity adjustments
will have no affect on any outputs
Set Input Termination
The "Input Termination" switch allows selection of DMX input
termination between Off and End. By factory default, this switch is set to
End.
• Set the switch to Off when the DMX Scene Controller is not the last
DMX device in the wire run.
• Set the switch to END when the DMX Scene Controller is the last
DMX device in the wire run.
Reset Power
Using a ballpoint pen, press the [Reset] button to reset the DMX Scene
Controller. This cycles power and restores the device to normal
operations.

Reset to Factory Defaults

Using a ballpoint pen, press and hold the [Reset] button for 10 seconds to
reset the DMX Scene Controller to factory defaults.
DMX Scene Controller Page 6 of 8 Echoflex