5 Remove the eight M2 x 3-mm screws (four on each side of the display
panel).
6 Lift the display panel out of the display back cover.
7 Press in both sides of the top flex-cable connector, and pull the top flex-
cable connector away from the display connector.
8 Use the pull-tab to disconnect the bottom flex-cable connector from the
inverter connector.
1
1
pull-tab on bottom flex-cable
connector
3
display cable connector
Replacing the Display Panel
1 Reconnect the top display-cable connector to the top flex-cable connector.
2 Reconnect the bottom flex-cable connector to the inverter connector.
3 Replace the display panel inside the display back cover.
2
4
2
top flex-cable connector
4
inverter connector
Adding and Replacing Parts
3
211