Tools And Materials Required - Profile Design HSA 800 EVO HYDRATION Manual

HSA 800 EVO
INTRODUCTION
Thank you for purchasing this Profile Design Hydration System. These instructions apply to both the standard and plus versions of the HSA 800 EVO.
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installing cycling accessories, please seek the assistance of your local Profile design dealer by logging on to
www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner's manual after installation.

Tools and materials required:

• 5mm Hex Wrench
• Torque Wrench with a 5mm Hex fitting
• Grease such as Finishline Premium Grease
Your kit should contain:
• Two (2) A3 Reach Extender
• Two (2) Stainless steel M6x35mm bolts
• Two (2) Washer
Caution! Before riding, ensure that the bolts are tightened to the torque specified in the Instruction Sheet.
1