Advertisement
J4 - J13: Trace port configuration
Soldered jumpers are by default placed to connect ARM CoreSight 20 connector trace signals to
port P18 (J9 – J13). If P18 on user target board is used for any other purpose than trace,
Emulation Adapter allows changing the trace source to port P22 (J4 – J8) with relocation of the
jumpers.
Soldered jumpers J4-J13 on EA on the image below:
www.tasking.com
Advertisement
Need help?
Do you have a question about the CYPRESS CYT2BL and is the answer not in the manual?
Questions and answers