Master/Slave Configuration - ADJ MEGA TRIPAR PROFILE PLUS User Manual

Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave set-up. In a Master-Slave
set-up, one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave, but only one unit can be programmed to act
as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units together via the XLR connectors on the rear of each unit. Use standard
XLR data calbes to link your units together. Remember that the male XLR connector is the input,
and the female XLR connector is the output. The first unit in the chain (master) will use the female
XLR connector only, and the last unit in the chain will use the male XLR connector only.
2. Set the "master" unit to the desired mode of operation.
3. Set the "slave" unit(s) to the desired DMX address. They will now follow the actions of the "mas-
ter" unit.
MASTER-SLAVE CONFIGURATION
12