ADJ MEGA TRIPAR PROFILE PLUS User Manual page 11

Default Running Mode:
This is a default running mode. When this mode is activated all modes will return to their default set-
tings.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
DMX State:
This setting defines the way that the unit will react in the event that the DMX signal is lost or inter-
rupted.
1. Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the
currently selected DMX address.
2. Press the SET UP button so that "nodn" is displayed. Use the UP and DOWN buttons to scroll
through the DMX states.
• "bLAC" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• "LASt" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX
set up. If power is applied and this mode is set, the unit will automatically go into the last DMX
set up.
• "ProG" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into
Auto Run mode.
3. Use the UP and DOWN buttons to find your desired DMX state and press SETUP to confirm and
exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See the Dimming Curves section of
this manual for details.
1. Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the
currently selected DMX address.
2. Press the SET UP button until "dr-X" is displayed. "X" represents the displayed dimmer curve:
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select the desired dimming curve.
ADJ LED RC2:
This function is used to activate and deactivate the wireless receiver. When activated, this allows
the unit to be controlled the ADJ LED RC2 remote control. Please see the ADJ LED RC2 Operation
section of this manual for details regarding controls and functions.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "IrXX" is displayed. "XX" represents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
OPERATING INSTRUCTIONS
11