ADJ MEGA TRIPAR PROFILE PLUS User Manual page 9

System Menu: The display will lock after 30 seconds. Press and hold the MODE button for 3
seconds to unlock.
LED Display On/Off:
To set the LED display to turn off after 10 seconds, press the MODE button until "don" is displayed,
then press the UP button to scroll to "doff". Now the display will disappear after 10s. Press any but-
ton to turn the display on again. Please note that the display will turn off automatically after 10 sec-
onds. To set the display press the MODE button until "dXX" is displayed. Use the UP or DOWN but-
tons to select either:
• "don" = LED display on at all times.
• "doFF" = LED display shuts off after 10 seconds.
LED Display Inversion:
Flips the display 180°, allowing the display to easily be read when the unit is mounting upside down.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "Stnd" is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Operating Modes:
The Mega TRIPAR Profile Plus has five operating modes:
• Sound-Active mode - The unit will react to sound, chasing through the built in programs. There
are 16 sound active modes.
• Color Macro Mode - There are 64 colors to choose from.
• Auto Mode - There are 3 Auto Modes to choose from.
• RGB+UV Dimmer Mode - Choose one of the four colors to remain static, or adjust the intensity of
each color to create a custom color.
• DMX control mode - This function will allow you to control each individual DMX trait using a stan-
dard DMX 512 controller.
RGB+UV Dimmer Mode:
1. Plug the fixture in and press the MODE button to adjust individual color settings. The options are
as follows:
• When "r.XXX" is displayed you are in Red dimming mode. Press the UP and DOWN buttons to
adjust intensity. Press SET UP to access green dimming.
• When "G.XXX" is displayed you are in Green dimming mode. Press the UP and DOWN buttons
to adjust intensity.
• When "b.XXX" is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust intensity.
• When "u.XXX" is displayed you are in UV dimming mode. Press the UP and DOWN buttons to
adjust intensity.
2. After you have adjusted the RGB & UV colors to make your desired color, you can adjust strobing
by pressing the SET UP button to enter the Flash (strobe) mode.
3. "FS.XX" will be displayed, indicating that the unit is in Flash mode. The Flash can be adjusted
between "FS.00" (flash off) to "FS.15" (fastest flash).
OPERATING INSTRUCTIONS
9