ADJ MEGA TRIPAR PROFILE PLUS User Manual page 13

ADJ LED RC2 OPERATION
The ADJ LED RC2 infrared remote (sold seperately) has many different functions and offers com-
plete control of your Mega TRIPAR Profile Plus. To control the fixture, the controller must be aimed
at the front of the fixture and be within the maximum range of 30 feet. To use the ADJ LED RC2, you
must first activate the fixture's infrared receiver, as instructed in the Operating Instructions section
of this manual.
BLACKOUT - Pressing this button will blackout the fixture.
PROGRAM SELECTION - This button will let you access color change mode, color fade mode, auto
run mode, or static color mode. Pressing this button will cause the unit to scroll to the next mode.
When you found your desired mode, use the "+" or "-" buttons to scroll through the programs or
static colors. When using the auto run, color fade, or color change modes, press the Speed button
and then use the "+" or "-" to adjust the running speed. The currently selected mode is indicated by
different colored flashes, as described below:
• If the Red LED's flash you are in Color Fade Mode.
• If the Green LED's flash you are in Color Change Mode.
• If the Blue LED's flash you are in Auto Run Mode.
• If the UV LED flashes you are in Static Color Mode.
FLASH - This button will activate the strobe effect. You can control the flash rate by pressing the "+"
and "-" buttons. Press this button again to exit strobe mode.
SPEED - Press this button and use the "+" & "-" buttons to adjust the speed of the auto run, color
change, and color fade, or to adjust the sound sensitivity in sound active mode.
DMX MODE - Pressing his button will scroll through DMX addressing, DMX Channel mode, DMX
last state setting, and dimming curves. When you reach your desired menu/submenu, use the "+" &
"-" buttons to scroll through the settings. See the DMX Traits section of this manual for full details
on DMX channel modes.
SLAVE/SA (SOUND ACTIVE) - This button activates sound active mode. The "+" and "-" buttons
are used to scroll through the 16 sound active programs. You can also use the number buttons to
select your Sound Active program. Press the Speed button to and use the "+" and "-" buttons to
adjust the sound sensitivity.
SET ADDRESS - Use to set the DMX address. Press the "SET ADDRESS" button first, then press
the numbers to set the address. Example: To set DMX Address as 1, press SET ADDRESS, then
press "0-0-1".
R G B A - Press any one of these buttons to select a color, and then press the "+" or "-" to adjust
the brightness. Note that for this device, "A" selects UV dimmer mode.
"+" and "-" - Use these buttons to adjust the flash rate, speed of the built-in programs, sound sensi-
tivity, and program selection.
13