Canon VB-C500D Operation Manual page 31

Note
If you want to set [Auto] for [Day/Night], conduct a thorough operation test and check the
effectiveness of the setting beforehand.
If [Auto] is selected under [Day/Night], set [Auto], [ Auto (Flickerless)], or [Auto (Shutter-
priority AE)] under [Exposure] on VB-C500 Viewer (
If [Night Mode] is selected, image does not become brighter even when infrared lamp is
used.
If [Auto] is selected under [Day/Night], zoom does not work while switching between [Day
Mode] and [Night Mode].
Installation Conditions
[Image Flip]
Select whether or not to output image after rotating it by 180°. Set [Enable] or [Disable]
according to the installation conditions of the camera. The factory setting is [Disable].
External Input Device 1, 2/External Output Device 1, 2
[External Input Device]/[External Output Device]
Be sure to enter each device name to identify the corresponding external device being
connected. Enter the device name (single-byte alphanumerics) using up to 15 characters
(ASCII characters (space or printable characters) excluding a double quotation mark (")).
Tip
If you are using Admin Viewer or optional recording software (VK-64/VK-16 or bundled
VK-Lite), the external device name set here will be displayed.
Setting the Camera Control and External Device Name (Camera)
P. 3-23).
1
1
1-17