Canon VB-C500D Operation Manual page 73

Note
The value set in [Maximum Frame Rate: Image Transmission] (
the frame rate set by this tool.
Tip
If the network load is heavy, the specified frame rate may not be achieved.
By setting a lower frame rate, the video extracted from the captured video will be included
in the scope of motion detection. This way, you can also perform motion detection for
slow-moving subjects, etc.
The frame rate set here is applied only to motion detection.
3. Set the motion detection area ([Area] tab).
Up to four motion detection areas can be created, where the frame of each area can be
resized/moved by dragging. To resize the frame, drag " " at four corners/on four sides. To
move the frame, drag a point inside the frame. You can also set a separate motion detection
level for each area. This camera lets you set the motion detection level while playing the video
recorded in the [Live] tab (
(1)[Motion Detection Area]
Select the check box corresponding to the motion detection area you want to use, and the
detection area frame will be displayed in the viewer. Up to four detection areas can be
created.
P. 2-16).
Motion Detection Setting Tool
P. 1-18) must be greater than
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
2-11