The Projected Image Is Blur; You Cannot Project An Image Appropriately; The Projector Is Forced To Be Turned Off - Canon RealIS WUX10 User Manual

■The projected image is blur.

Cause
The image is out of focus.
The distance to the screen is too
short.
The projector is not placed straight
in front of the screen.
The projector has been moved to a
place where the temperature var-
ies a lot.
The lens is stained.
The tracking is bad.

■You cannot project an image appropriately.

Cause
The projected image is inverted in
the vertical or horizontal direction.
The dot clock of the inputted sig-
nal is 170MHz or higher with a
BNC cable.
Using a VGA cable in which some
pins are not connected.

■The projector is forced to be turned off.

Cause
The air intake or exhaust vent is
blocked.
The air filter is dirty.
Countermeasure
Adjust the focus. (P52)
Check whether the distance to the screen is appropriate. If
the distance is shorter than approximately 1.2m (3.9'), the
projector cannot focus on the screen. (P31, P129)
Check whether the projector is placed obliquely to the
screen. A slight error in the projection angle can be cor-
rected through the keystone adjustment function. (P53)
When the projector is moved from a low-temperature place
to a high-temperature place, condensation may form on the
lens. The condensation will evaporate a while later and the
projector will be able to project a normal image.
Clean up the lens. (P121)
Adjust the tracking with the [AUTO PC] or [Tracking] func-
tion. (P50, P76)
Countermeasure
The ceiling mounted/rear projection setting is incorrect.
Check the [Image flip H/V] setting in the [Display settings]
menu. (P81)
Set the signal dot clock to 170MHz on your computer.
Use a VGA cable in which all pins are connected.
Countermeasure
Check whether the air intake or exhaust vent is blocked. If the
air intake or exhaust vent is blocked, the temperature inside
the projector rises and the power is automatically turned off
to protect the projector. (The WARNING lamp flashes once.)
Wait until the internal temperature gets down, and then turn
on the projector without blocking the intake and exhaust
vents. (P22, P23, P42)
Check whether the bottom air filter is clogged with dust.
If the air filter is clogged, clean or replace the air filter. (P122)
119
Troubleshooting