Cleaning And Replacing The Air Filter; Cleaning The Air Filter; Replacing The Air Filter - Canon RealIS WUX10 User Manual

Maintenance

Cleaning and Replacing the Air Filter

An air filter is installed in the air intake vent on the bottom of the main body to protect the
internal lens and mirror from dust. Should the air filter become clogged with dust, the pro-
jector may be damaged since it will block the air flow into the projector and raises the
internal temperature of the projector. The following screen is displayed when turning on
the projector if the air filter needs to be cleaned. Clean the air filter if such is the case.

■Cleaning the Air Filter

• Turn the projector upside down, remove the cover by pushing the latch, remove the air
filter, and clean it with a vacuum cleaner.
• When cleaning dust off the side exhaust vent and the bottom air intake vent, bring the
vacuum cleaner nozzle close to them directly.
• If the above screen is displayed when turning on the projector after cleaning the air fil-
ter, select [Yes].

■Replacing the Air Filter

Make sure to replace the air filter when replacing the lamp.
Follow the following procedure when replacing the air filter.
1
Turn off the projector, disconnect the
power plug from the AC outlet, and let
the projector stand for at least 1 hour.
2
Remove the filter cover by pushing the
position of the arrow.
3
Remove the air filter.
4
Install a cleaned or new air filter.
5
Install the filter cover securely without
any space.
• Handle the air filter carefully. If damaged, the air filter will not work appropriately
• An air filter can be ordered from your dealer.
• Only [<], [>], the OK button, and the POWER button
are available while this screen is displayed (When
you press the POWER button, "Push POWER button
again to turn off power." message appears).
• After this screen has been displayed for 10 seconds
and disappeared, all buttons become operable.
122
Filter cover
Air filter
Push