PCL
I/O TIMEOUT=
15
I/O TIMEOUT (input/output timeout) is the amount of time (measured in seconds)
that the printer waits for more data before it ends a print job. If data from other ports
frequently arrive in the middle of a print job, increase the setting.
This timeout setting is for the optional interface port only. You can also set the timeout
for the parallel interface (see page 78).
15
5 to 3000
82
The Standard Printing Environment Settings
The printer is dedicated to the PCL personality and will not switch
to the PostScript personality automatically if it receives a PostScript
print stream. However, special commands sent to the printer with
the print stream can force the printer to switch to the PostScript
personality.
*
The timeout is set for 15 sec.
To increase the number, press Value; to quickly scroll to a higher
number in increments of 10, press and hold down Value.
To decrease the number, press Shift and Value; to quickly scroll
back to a lower number in decrements of 10, press and hold down
Shift and Value.
In addition to the items above, this menu allows you to set the following
four network settings:
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
MAC ADDRESS
Please consult the Getting Started Guide for detailed information on
configuring the settings.