Engine and radiator protection, underbody armour for volkswagen amarok (2010-2016, 2016- ) (16 pages)
Summary of Contents for Rival 2M.1802.K
Page 1
FORD RANGER (2022-ON) / RANGER RAPTOR (2022-ON) / VOLKSWAGEN AMAROK (2023-ON) PART NO: 2M.1802.K Front CAUTION! To reduce the risk of serious injury or damage, please read and understand all instructions and procedures before attempting to install or use this product. Safety glasses must be worn at all times during installation or maintenance of this product.
2.1inch (52mm) SAFETY NOTICE * The RIVAL roof rack is designed to compliment the use and design of the specified vehicle under conditions specified by the car manufacturer. * While driving the vehicle at any speed, collision with any other vehicle, animal or object must always Front be avoided.
PARTS LISTING 1. Left bracket ............Qty 1 2. Right bracket............Qty 1 3. Wind deflector............. Qty 1 4. Wind deflector bracket........Qty 1 Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 3 of 12 >...
Page 4
J. Sealant............. Qty 1 K. Nut M8............. Qty 12 L. Flat washer 8........... Qty 8 M. Reinforced flat washer 8......... Qty 4 Plastic cap for nut М8........Qty 4 Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 4 of 12 >...
Page 5
3. Remove sun visors, using plastic trim tool and ratchet wrench, as shown in fig.5 and fig.6. * If the vehicle is equipped with mirror lighting, carefully detach the wire connectors from the sun visors. Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com...
Page 6
5. Remove the pillar seat belts, using plastic trim tool and ratchet wrench, as shown in fig.9 and fig.10. Fig. 11 Fig. 12 6. Pull down the rubber seal on all doors, as shown in fig.11 and fig.12. Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 6 of 12 >...
Page 7
9. Remove the bolts and rubber stoppers from the rear panel (fig.16). RIVAL... Fig. 17 Fig. 18 10. Remove the rear panel (fig.17). 11. Loosen the lower pillar covers by unclipping at the top (fig.18). Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 7 of 12 >...
Page 8
(fig.22). Fig. 23 Fig. 24 16. Open the sunglesses compartment and 17. Carefully detach the wire connectors from pry the cosole downward (fig.23). the center console (fig.24). Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 8 of 12 >...
Page 9
(fig.29). the spacers to the center holes using bolts M8x16 (item C), spring washers 8 (item H) and reinforced flat washers (item M) (fig.30). *Do not tighten yet. Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 9 of 12 >...
Page 10
Fix it using washers 8 (item I) and nuts М8 (item K) (fig.34). *Tighten hardware after that. Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 10 of 12 >...
Page 11
M6x20 (item D) washers 6 (item on the rear nuts M8 (item K) installed on step G) and washers spring 6 (item F) (fig.40). 25 (fig.41). Installation manual 2M.1802.K www.rival4x4.com Date: 29-Nov-2022 < Page 11 of 12 >...
INSTALLATION PROCEDURE Before operating a vehicle fitted with a RIVAL Roof rack: - make sure all fittings are tightened Thank you for your choice! Sincerely, RIVAL 4x4 Team Installation manual 2M.1802.K Date: 29-Nov-2022 www.rival4x4.com < Page 12 of 12 >...
Need help?
Do you have a question about the 2M.1802.K and is the answer not in the manual?
Questions and answers