Extreme Networks Extreme Management Center ExtremeControl IA-A-25 Installation Manual page 15

=================================================================
The engine date and time can be set manually or using an external Network Time Protocol
(NTP) server. It is strongly recommended that
NTP is used to configure the date and time to ensure accuracy of time
values for SNMP communications and logged events. Up to 5 server
IP addresses may be entered if NTP is used.
=================================================================
Do you want to use NTP (y/n) [y]? y
Please enter a NTP Server IP Address (Required): 144.131.10.120
Would you like to add another server (y/n) [n]? y
Please enter a NTP Server IP Address (Required): 144.131.10.121
Would you like to add another server (y/n) [n]? n
7 In the NTP validate selection screen, enter 0 to accept the current settings and proceed to the Set
Time Zone screen at step 10.
=================================================================
NTP Servers
=================================================================
These are the currently specified NTP servers. Enter 0 or any key other than a valid
selection to complete NTP configuration and continue.
If you need to make a change, enter the appropriate number from the choices listed
below.
144.131.10.120
144.131.10.121
0. Accept the current settings
1. Restart NTP server selection
2. Set date and time manually
=================================================================
Enter selection [0]: 0
8 If you answered no to using an NTP server to set date and time, set the date and time in the Set Date
and Time screen.
=================================================================
Set Date And Time
=================================================================
The current system date and time is: Thu Apr 24 09:34:08 2008
Please enter the values for date and time as directed where input is expected in the
following format:
MM - 2 digit month of year
DD - 2 digit day of month
YYYY - 4 digit year
hh - 2 digit hour of day using a 24 hour clock
mm - 2 digit minute of hour
ss - 2 digit seconds
=================================================================
Please enter the month [06]:
Please enter the day of the month [24]:
Please enter the year [2013]:
Please enter the hour of day [09]:
Please enter the minutes [34]:
Please enter the seconds [34]:
9 In the Use UTC screen, select whether you want the system clock to be set to use UTC.
=================================================================
Use UTC
=================================================================
The system clock can be set to use UTC. Specifying no for using UTC, sets the hardware
clock using localtime.
=================================================================
Do you want to use UTC (y/n) [n]?
ExtremeControl IA-A-25 Installation Guide for version 8.1
Configuration
15