Paradox IP150+MQ Installation Manual page 6

2) Enter the IP reporting account numbers (one for each partition):
MG/SP: section [918] / [919]
EVO: section [2976] to [2978]
EVOHD+ section [2976] Receiver 1 Main
Note: For EVOHD+ panels, Receiver 2 Backup and Receiver 3 Parallel automatically assumes the account
number of Receiver 1 Main and cannot be modified.
3) Enter the monitoring station's IP address(es), IP port(s), and security profile(s) (information must be obtained from
the monitoring station).
Note: The IP150+MQ can report only to two receivers.
MG/SP Sending IP Credentials to Receiver
IP Receiver
Save and Send/Status
Email Configuration (only with open networks)
Configure the IP150+MQ's email server settings.
configuration.
Email Addresses
MG/SP Sections
IP Receiver #1
IP Address 1 [929]
IP Port 1 [930]
IP Profile [934]
EVO Sections
IP Receiver #1
IP Address 1 [2984]
IP Port 1
IP Profile
You can configure your IP150+MQ to send email notifications to up to four email addresses to receive notification of
system events.
To configure an email address:
1) In BlueEye app, Installer Menu, Module Configuration section, enable the Address toggle button.
2) Enter the Email address. Use the test button to verify that the recipient's address is correct.
#1 #2 #3
[935] [942] [949]
Please note that emails are not supported in a closed network
#2 #3
[936] [943]
[937] [944]
[941] [948]
#2 #3
[2986] [2988]
EVO/EVOHD+ Sending IP Credentials to Receiver
IP Receiver
Save and Send/Status
EVOHD+
IP Receiver Main #1
IP Address 1 [2984]
IP Port 1
IP Profile
Main Parallel
[2985] [2987]
Backup #2 Parallel #3
[2986] [2988]
The IP profile for this receiver
is the same as the
Main receiver IP profile.
Page 6
Backup
[2989]