Advertisement
Before You Begin
Make sure you have the following to configure your IP150+MQ Internet Module:
Router
•
4-pin serial cable (included)
•
CAT5 Ethernet cable (maximum 90m (295 ft.), not included)
•
BlueEye app installed in a smartphone
•
Connect IP150+MQ to the serial port on your panel and Ethernet port of your router
•
Installation
IP150+MQ
The IP150+MQ should be installed in the panel metal box enclosure to be tamper-protected. Clip the IP150+MQ to
the top of the metal box, as shown in Figure 1.
Serial to the Panel
Connect the serial output of the IP150+MQ to the Serial port of the Paradox panels. If it is Paradox + Series,
connect it to Serial1 as it is the main reporting channel, as shown in Figure 4. If the panel is powered up, the
on-board LEDs will illuminate to indicate the IP150+MQ's status.
Ethernet
Connect the Ethernet cable to an active Ethernet socket and the left side of the IP150+MQ, as shown in Figure 4.
Attaching the IP150+MQ to the Panel
To connect the IP150+MQ, plug in the Serial cable to panel, refer to Figure 4. After a few seconds, the
RX/TX LED starts flashing; this indicates that the IP150+MQ is powered and is communicating with the
panel.
Metal Box
Figure 1
Page 2
Advertisement
Need help?
Do you have a question about the IP150+MQ and is the answer not in the manual?
Questions and answers