Angelo Po 0S1FR1ED User Manual page 34

ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
► Source of hazard: handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of injury • When the appliance
due to body moves
overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND COMMISSION-
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below:
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing parts
of the body in case of
tip-over or fall of the
appliance
Risk of cutting due
to sharp edges
Risk of crushing parts
of the body in case of
fall of the appliance
6
ING, ADJUSTMENTS AND PART REPLACEMENT
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the cen-
When handling sheet-metal
parts
In case of uneven or sloped
fl oors
Countermeasures
• Use a suitable lifting de-
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values for
lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
Countermeasures
tre of gravity
• Avoid collisions
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct
installation requirements
as per section "Installing
the appliance" on page 10
of the installation manual.
SAFETY
Safety device
• Protective gloves
• Protective shoes
• Safety helmet
(e.g. for sus-
pended loads,
overhead opera-
tions...)
Safety
device
None
None
None
3395270_ut_GB